- Manual Draw Bar
- Hard-Chromed Ways
- Front & Rear Rubber Way Covers
- One-shot Lube System
- Digital variable speed. (Note: 440V requires additional transformer )
Single phase is available for this model
- Tool Kit:
Machine Manual, Half-Nut Wrench,
Wrench 17m, 19m, Set of 6 Allen Wrenches, Philip
Screw Driver, Flat Head, Screw Driver, Oil Can,
Grease Gun, Rear Way Cover Bracket, Pin for Indicator, and Can of Paint
- Hardened & Ground Box ways on Column & Saddle for Maximum Rigidity
- 3 HP Motor
- R-8 Spindle
- Knuckle joint using bolts & circular T-slot design;
allowing head to swivel left & right, up & down
- Double-Nut Backlash Eliminator
- Internal Lubricated Vari-Disc Design
- Motor shaft end supported by bearing
Model TMV DVS
Working Surface 10" x 50"
T-Slots Number and Size 3 Slots, 5/8"
Saddle Width 26"
Travels (X,Y) 34.75" x 16.3"
Quill Travel 5"
Ram Travel 18.5"
Knee Travel 15.3"
Throat Distance 9.8”-28.3”
Spindle Gage line to Tabletop 5.375” - 16.9"
Spindle Motor 3HP
Wiring Voltage 220V / 440V
Spindle Nose Taper R-8
Spindle Variable Speed Drive 60-4500 rpm
Quill Feed 3 Speed (IPR) 0.0015, 0.003, 0.005
Accuracy 0.0002" TIR
Head Tilt (Right to Left) 90°
Head Tilt (Up and Down) 45°
Dimensions and Weight
Floor Area (W x D x H) 70" x 75" x 91.78"
Weight 3000 lbs
Total Power Consumption
220V 3KVA / 8 amps
440V 3KVA / 4 amps